ELASTOSIL® AUX STABILIZER H0
ELASTOSIL® AUX STABILIZER H0 is a ready-to-use additive comprising a heat stabilizing filler and a reactive silicone polymer which is a typical ingredient of ELASTOSIL® high-consistency rubber grades. This ensures that the batch is incorporated into the elastomer network during vulcanization and thus does not show any migration.
- Thanks to its paste character, ELASTOSIL® AUX STABILIZER H0 can easily be incorporated into ELASTOSIL® R and R plus mixtures on two-roll mills.
- No impairment of ELASTOSIL® R and R plus grades when dosage recommendations are observed.
- Compatible with curing agents ELASTOSIL® AUX CURING AGENT C1, C6 and E as well as ELASTOSIL® AUX BATCH PT 1 and PT 2.
Further information about an improvement of the heat stability by use of specific ELASTOSIL® AUX Heat Stabilizers can be obtained from the Technical Information Sheet "ELASTOSIL® AUX Stabilizers H" or the latest edition of our brochures.
Specific features of ELASTOSIL® AUX STABILIZER H0
- Good heat stability
ELASTOSIL® AUX STABILIZERs H are used to extend the service life of silicone elastomers at temperatures above 170 °C. The maximum recommended service temperature for use of ELASTOSIL® AUX STABILIZER H0 is 225 °C.
ELASTOSIL® AUX STABILIZERs H are incorporated into ELASTOSIL® R and R plus high-consistency rubber using standard mixing techniques. Good results are obtained by incorporating the curing agent at the same time.
The recommended dosage of ELASTOSIL® AUX STABILIZER H0 is 2 %.
For detailed information please refer to the latest edition of our brochure "SOLID AND LIQUID SILICONE RUBBER - MATERIAL AND PROCESSING GUIDELINES"
This product is available in 1 kg carton and 20 kg cardboard box
Please store the cardboard boxes in a dry and cool place; not exceeding temperatures >30°C for longer periods of time. Already opened boxes should be tightly closed again to avoid any contamination and sunlight exposure.
The “Best use before end” date of each batch is shown on the product label. Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.