ELASTOSIL® N 2034

ELASTOSIL® N 2034 is a self-levelling, Alkoxy-cure one-component silicone sealant, which cures at room temperature under the influence of moisture.

It shows excellent primerless adhesion to many substrates.

 



Properties

  • flame retardant (meets UL 94 V-0)
  • self-levelling
  • Recommended service temperature from -45 °C to +180 °C

Specific features of ELASTOSIL® N 2034

  • Excellent adhesion
  • Flame retardant
  • Good heat stability
  • Low viscosity
  • Non-corrosive to metals
  • One-component
  • Ready to use

Disclaimer

All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.

Multipurpose grade for sealing and bonding such as FIPG-applications for e.g. automotive headlamps

ELASTOSIL® N 2034 is a ready-to-use, acid- and sovent-free, non-corrosive RTV-1 (room temperature vulcanizing, one-component) silicone rubber suitable for many applications.
Excellent adhesion to plastics and metals in combination with a high elasticity and durability open up a wide range of potential uses for ELASTOSIL® N 2034. The consistency of the uncured material allows a high application rate and makes it a good choice not only for dispensing from a caulking gun but also for automatic dispensing. 

The fully cured rubber can withstand expansion-compression cycles for many years and is therefore especially well suited for joining materials with different coefficients of thermal expansion. The vulcanized silicone rubber permanently remains elastic over a wide temperature range from -50 °C to +180 °C (-58 °F to +356 °F).

If removing of silicone rubber from machines or dispensing equipment is necessary, white spirit is recommended as a solvent. However, cleaning should take place before the rubber is fully cured. Afterwards only the use of mechanical forces in combination with a swelling solvent or the use of high temperatures of approximately 100°C will help to remove sealant residues.

We recommend to run preliminary tests to optimize conditions for the particular application.

Detailed processing instructions are given in our brochure “ROOM TEMPERATURE VULCANIZING (RTV) SILICONES - MATERIAL AND PROCESSING GUIDELINES

Storage

The 'Best use before end' date of each batch is shown on the product label.

Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemical Corporation
3301 Sutton Road
Adrian, MI 49221-9397
United States
+1  888  922-5374 (Phone)
+1 517 264-8246  (Fax)
Kontakt
Website

How can we help you?

    Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Ask a question

Would you like a product sample?

You can request a product sample here.

Request sample

More products

Please choose an application for viewing your product matches.