ELASTOSIL® A07 TRANSLUCENT

ELASTOSIL® A07 TRANSLUCENT is a free flowable, solvent-based RTV-1 silicone dispersion. It cures at room temperature or elevated temperature by reaction with air humidity to a flexible silicone coating. During cure it splits off an organic amine.



Properties

  • ready-to-use, one-component system
  • low module
  • excellent primerless adhesion to many substrates
  • no use of organotin catalysts

Specific features of ELASTOSIL® A07 TRANSLUCENT

  • Product Rheology: Flowable
  • Product Rheology: Low viscosity
  • Regulation: Solvent-based
  • Resistance: Flexible at low (-40 °C) and high temperatures (+180 °C)
  • Specific Features: Low viscosity
  • Specific Features: Solvent-based
  • Vulcanizate: Flexible at low (-40 °C) and high temperatures (+180 °C)

Disclaimer

All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.

Multipurpose sealant and coating  material.

ELASTOSIL® A07 TRANSLUCENT is a free flowable, solvent-based RTV-1 silicone dispersion. It cures at room temperature reaction with air humidity to a flexible silicone coating. During cure it splits off an organic amine.

It can be applied by dipping, spraying, brushing or coating. Thinner coatings can be obtained by addition of solvents (e.g. toluene, white spirit), thicker coatings can be realised by multiple step coating.

The product contains about 25% of solvent (b.w.) therefore suitable equipment has to be used and precaution measures due to the solvent vapours have to be taken.

ELASTOSIL® A07 TRANSLUCENT is a one-part room temperature curing coating therefore the curing rate depend atmospheric humidity. The curing rate can be accelerate on exposure to carbon dioxide concentration above 1% p.b.v.


Uncured or partially cured silicone can be removed by help of organic solvents such as alipatic or aromatic hydrocarboncleaning should take place before the rubber is fully cured. Once completely cured, only mechanical removal supported by prior solvent swell is possible. In thin films, Wacker Silicone Remover S8 is suited as well.

 

Detailed processing instructions are given in our brochure “ROOM TEMPERATURE VULCANIZING (RTV) SILICONES - MATERIAL AND PROCESSING GUIDELINES

Storage

The 'Best use before end' date of each batch is shown on the product label.

 

Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemical Corporation
3301 Sutton Road
Adrian, MI 49221-9397
United States
+1  888  922-5374 (Phone)
Contact

How can we help you?

  • Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Ask a question

Would you like a product sample?

You can request a product sample here.

Request sample

More products

Please choose an application for viewing your product matches.

Order

My media


My favorites

My products