ELASTOSIL® E303 TRANSLUZENT
ELASTOSIL® E303 TRANSLUZENT is an acetoxy-cure, free flowable, solvent-based RTV-1 silicone dispersion. It cures at room temperature or elevated temperature by reaction with air humidity to a flexible silicone coating.
- free flowable material for coating and sealing applications
- Application by brushing, dipping, spraying
- for robust and thin protective coatings
Specific features of ELASTOSIL® E303 TRANSLUZENT
- 1-component system
- Good adhesion to metals, glass and ceramics
- Low viscosity
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
- Protective coating against moisture and environmental influence
- Thin film coating for sealing applications
Typical application is selective coating of heat exchangers (automotive radiators).
ELASTOSIL® E303 TRANSLUZENT can be applied by
Thinner coatings can be obtained by addition of solvents (e.g. toluene, white spirit), thicker coatings can be realised by multiple step coating.
ELASTOSIL® E303 TRANSLUZENT contains about 55% of solvent therefore suitable equipment has to be used and precaution measures due to the solvent vapours have to be taken. A volume shrinkage of slightly above 50% has to be considered.
ELASTOSIL® E303 TRANSLUZENT is a one-part room temperature curing coating therefore the curing rate depends on temperature and on atmospheric humidity. The curing rate can be accelerated by heat.
Uncured or partially cured silicone can be removed by help of organic solvents such as alipatic or aromatic hydrocarboncleaning should take place before the rubber is fully cured. Once completely cured, only mechanical removal supported by prior solvent swell is possible. Swelling can be accelerated by elevated temperature. In thin films, Wacker Silicone Remover S8 is suited as well.
We recommend running preliminary tests to optimize conditions for the particular application.
Detailed processing instructions are given in our brochure “ROOM TEMPERATURE VULCANIZING (RTV) SILICONES - MATERIAL AND PROCESSING GUIDELINES
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.
Sales and support
How can we help you?
- Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Would you like a product sample?
You can request a product sample here.Request sample