ELASTOSIL® A 95 GREY

Moisture Curing Silicone Rubber (RTV-1) ELASTOSIL®
ELASTOSIL® A 95 GREY is a one part thixotropic sealant intended for use where a soft, high elongation material is desired. ELASTOSIL® A 95 GREY is particularly effective as an adhesive in applications where the bonded joint is subjected to relatively large movements in service.
Download Sales Contact

Properties

  • Tenacious adhesion to most metals, plastics, synthetic rubbers, glass and concrete
  • Resistant to hot lubricating oils
  • Low modulus of elasticity for superior sealant joint movement capability
  • Low compressive modulus, ideal for forming compression gaskets on covers and closures where low clamping pressures are essential
  • Stays flexible between -54°C and +204°C (-65°F and +400°F)
  • Impervious to weathering and ultraviolet degradation
  • Non-corrosive to ferrous metals
Data sheets
TDS Technical data sheet
PDF 46.1 KB
English

ELASTOSIL® A 95 GREY can be bulk dispensed to hand or robot applicators with conventional drum and pail extruder pumps equipped with high-pressure flexible fluid hoses. Caution! Hose pressure rating must exceed the maximum possible output of the pump and be moisture impermeable. Contact your Wacker Silicones representative for equipment recommendations. Surfaces to be bonded must be clean and free of oil, grease, soaps, dust, etc. Rubbers and plastics must be free of die lubricants and mold release agents. Certain plastics such as polypropylene require flame treatment to attain maximum adhesion.

 

Storage

The "Best use before end date" of each batch is shown on the Certificate of Analysis. Storage beyond the date specified on the Certificate of Analysis does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemical Corporation

S State Road 4950

Ann Arbor, MI 48108

United States

+1  888  922-5374