ELASTOSIL® LR 3003/80 US A/B

Liquid silicone rubbers of the ELASTOSIL® LR 3003/80 US A/B series are paste-like, easily pigmentable two-component compounds. They are noted for their high transparency, excellent mechancal and electrical properties and their ability to be molded into intricately-shaped, precision parts. This series is used for health care applications, including short-term implants. Very brief molding cycles for intricately-shaped and flash-free parts are possible.



Properties

  • ELASTOSIL® LR 3003/80 US A/B has been tested according to the recommendations of the US Pharmacopoeia and meets the requirements of Class Vl.
  • ELASTOSIL® LR 3003/80 US A/B contains only those ingredients1 which are suitable for food contact.
  • Excellent mechanical properties
  • Excellent clarity
  • Excellent molding qualities
  • Excellent pot life after mixing parts A & B

Disclaimer

All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.

  • Medical devices
  • Needle-free IV valves
  • Drink valves
  • Diaphragms
  • Soft-Touch handles and buttons
  • Organic rubber replacement




Fabricating Liquid silicone rubbers of the ELASTOSIL® LR 3003/80 US A/B series can be processed using standard liquid rubber injection molding techniques. Vulcanization Liquid silicone rubbers of the ELASTOSIL® LR 3003/80 US A/B series are vulcanized by mixing part A with part B in a ratio of 1:1 with the application of heat. Mold temperatures are usually in the range of 160 °C (320 °F) to 210 °C (410 °F). Actual mold temperature and cycle times will be dependent upon a number of factors. Cycles times may be as little as 15 seconds for small parts.

 

ELASTOSIL® LR 3003/80 can be fabricated using standard liquid rubber injection molding techniques. The product is delivered equal parts A/B and designed for a 1:1 (A;B) mix ratio.  With proper lmetering equipment, it can be pumped directly through a statixc mixer into the injection molding machine. 

Storage

The "Best use before end date" of each batch is shown on the Certificate of Analysis. Storage beyond the date specified on the Certificate of Analysis does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemical Corporation
3301 Sutton Road
Adrian, MI 49221-9397
United States
+1  888  922-5374 (Phone)
Contact

How can we help you?

  • Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Ask a question

Would you like a product sample?

You can request a product sample here.

Request sample

Order

My media


My favorites

My products