VINNAPAS® 7034 E
VINNAPAS® 7034 E is a dispersible polymer powder for dry mix mortars, specifically suited for renders and plasters and concrete repair. It is based on a flexible terpolymer of vinyl acetate, ethylene and vinyl ester. VINNAPAS® 7034 E belongs to the product class VINNAPAS® E which means that it provides enhanced properties like improved workability, adhesion or water resistance, to name just a few.
- VINNAPAS® 7034 E is a terpolymer powder of vinyl acetate, vinyl ester and ethylene and is dispersible in water.
- Compounds modified with VINNAPAS® 7034 E exhibit improved adhesion, flexural strength in bending, deformability, abrasion resistance and are easier to process. Leveling, thixotropy and water retention are essentially unaffected.
- The product is ideal for use in combination with other mortar additives intended to enhance specific properties.
- VINNAPAS® 7034 E contains a fine mineral filler as an antiblocking agent and is produced without the addition of organic solvents, plasticizers and film-forming agents.
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
For typical application fields of VINNAPAS® 7034 E you can refer to the section "application". VINNAPAS® 7034 E can be also used for soil stabilization. Please discuss additional applications with your WACKER customer representative.
For the production of ready-mixed dry mortars, such as adhesives and patching compounds, blend VINNAPAS® 7034 E with the other dry ingredients in appropriate equipment. Temperatures should not be allowed to rise excessively during mixing because otherwise the dispersible polymer powder could agglomerate by virtue of its thermoplastic properties. The mortar is prepared for use by adding the recommended amount of water and mixing mechanically or by hand. Since hand mixing generates little shear force, we recommend allowing the fresh mortar to slake for 5 minutes and then stirring it again. This is usually unnecessary where mechanical mixers are employed.
If the product is used in applications other than those mentioned, the choice, processing and use of it is the sole responsibility of the purchaser. All legal and other regulations must be complied with.
Slight color variations of the polymer granulate may occure without impairing the product's functionality.
Big Bags or bulk on request.