POWERSIL® 466 LV A/B
POWERSIL® 466 LV A/B is a liquid silicone rubber with medium conductivity and excellent mechanical properties.
- ready-to-use, two-component system
- high elongation at break, low tension set
- stable electrical properties
- good mechanical properties
Specific features of POWERSIL® 466 LV A/B
- Electrically conductive
- Low viscosity
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
POWERSIL® 466 LV A/B is suitable for production of electrically conductive injection moulded articles, especially cable accessories in the medium and high voltage range.
The range of use spreads from push-on accessories to cold shrink applications. POWERSIL® 466 LV A/B combines a low Shore A durometer with high elongation, good setting properties (low tension set) and good mechanical properties which are a must for cold shrink applications.
POWERSIL® 466 LV A/B is a low viscosity LSR that shows excellent processing properties.
Components A and B are delivered ready to use in drums of 20 and 200 litres capacity. They can be pumped by means of standard metering equipment from these drums and mixing in a static mixer straight into the heated mold.
The mixing ratio is 1 : 1. At room temperature, mixtures of A and B components have a pot life of at least three days.
For detailed information, refer to brochures on www.wacker.com.
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.