ELASTOSIL® M 4511
Pourable, condensation-curing, two-component silicone rubber that vulcanizes at room temperature.
Main application: Making cost effective molds, specially suited for casting PE and PU resins.
Eigenschaften
- very good flowability and self-deaeration
- very low Shore A hardness (approx. 12)
- high tear strength
- extremely high elongation and flexibility
- outstanding chemical resistance to attack by polyester and polyurethane resins, mold life is significantly extended
Spezifische Merkmale von ELASTOSIL® M 4511
- Condensation-curing
- Flowable
- Resistance against polyester
- Resistance against PU
- Two-component
Datenblätter
ELASTOSIL® M 4511 is a high-performance moldmaking compound, which is particularly suitable for the reproduction of models with extensive undercuts. ELASTOSIL® M 4511 is especially suitable for the processing of polyester and polyurethane resins.
Due to its very high extensibility and low flexural modulus, ELASTOSIL® M 4511 is best suited for the reproduction of fine or fragile models, where the piece may be damaged by more rigid molding materials on demolding.
ELASTOSIL® M 4511 exhibits low hardness and high strength, plus excellent ink transfer characteristics. These make it a perfect base material for the production of printing pads.
Für die Herstellung von Formen zur Verarbeitung von Epoxid- und Polyurethan-Harzen erfolgt die Verarbeitung von ELASTOSIL® M 4511 durch Zusatz von 5 Gew.-% Härter T 21.
Für die Reproduktionsmaterialien Polyesterharze, Gips, Beton, Kunststein, Wachs und niedrigschmelzende Metalllegierungen sollte dagegen der Härter T 51 eingesetzt werden (5 Gew.-%).
Die Topfzeiten und Vulkanisationszeiten beider Härter können durch Abmischung mit Härter T 47 verkürzt und somit den jeweiligen Anwendungserfordernissen exakt angepasst werden.
Zur schnelleren Vulkanisation kann der jeweilige Härter mit Härter T 47 abgemischt werden. So verringert sich z.B. bei einem Verhältnis von 95 : 5 (T51 : T47) die Topfzeit auf ca. 30 min, die Form ist dann bereits nach ca. 4 h vulkanisiert.
Weitere Anleitungen zur Abmischung der Härter mit Härter T 47 entnehmen Sie bitte dem Datenblatt "WACKER®-Härter der Reihe T".
Die angeführten Verarbeitungszeiten geben die Zeitspanne bei 23 °C / 50 % rel. Luftfeuchte bis zum Erreichen einer Viskosität von 100000 mPa s an, bei der die Masse gerade noch gießbar ist.
Bitte beachten Sie auch unsere Broschüren und Informationsblätter.
Lagerung
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.
Vertrieb & Support
20090 Vimodrone (MI)
Italien
39 2 72003288 (Fax)
Webseite
Wie können wir Ihnen helfen?
- Benötigen Sie Unterstützung bei der Produktauswahl oder wünschen Sie eine technische Beratung? Kontaktieren Sie unsere Experten.