WACKER® eco CATALYST C 05
WACKER® eco CATALYST C 05 is a highly-active, diluted platinum catalyst used for the thermal curing of solvent-based and solvent-free, addition-crosslinking silicones.
WACKER® eco CATALYST C 05 is based on renewable raw materials according to “Standard REDcert²”. In the WACKER® eco CATALYST C 05manufacturing process, the use of fossil-based raw materials is compensated 100% by biomethanol from renewable resources.
- Very high and constant catalyst activity
- Ideally suitable for automated mixing units
- Rapid curing of addition-crosslinking silicone systems
- Miscible with silicones in all proportions
WACKER® eco CATALYST C 05 is dissolved in a reactive silicone polymer, which is incorporated into the cured rubber during the curing process. Combined with DEHESIVE® silicone polymers, it is excellently suited for providing various substrates, such as paper and films, with a silicone coating that exhibits release properties towards tacky products used in technical, health, hygiene and food sectors.
WACKER® eco CATALYST C 05 must be added to the mixture of DEHESIVE®, CRA® modifier and crosslinker. During addition, stirring should be as rapid as possible to avoid local over-concentrations of the platinum catalyst, which cause premature curing indicated by formation of gel particles ranging in color from brown to black. It is also important that the platinum catalyst is always added as the last component to the homogeneous mixture of polymer and crosslinker.
Its relatively low platinum content means that WACKER® eco CATALYST C 05 is ideally suited for the use in automated mixing and metering equipment. Furthermore, problems with gelation are easier to keep under control when is employed. Before switching from concentrated to diluted catalysts and vice versa, lab tests must be carried out to make sure that this will have no effect on the release values.
WACKER® eco CATALYST C 05 contains a considerable amount of a reactive silicone polymer as solvent for the platinum complex. This must be taken into account when WACKER® eco CATALYST C 05 is used in formulations containing CRA® modifier (e.g. when increasing or decreasing the amount of WACKER® eco CATALYST C 05 in the formulation). The release force for the cured silicone coating will remain constant as long as the percentage of CRA® modifier does not change.
Suitable materials for mixing vessels, stirrers, pumps, tubes, filters, etc. are stainless steel, polyethylene, polypropylene, Teflon and other fluorine polymers, as well as products coated or lined with these materials. If good catalyst activity is to be maintained, it is essential to avoid deactivation of the platinum catalyst. This may occur as a result of contact with the abovementioned equipment, with the ambient air, with unsuitable rolls in the coating equipment, with the customer's additives, or even with the substrate to be coated. If heavy metals (e.g. lead, copper, zinc, iron, chromium or tin) or sulfurous, nitrogenous or phosphorous organic compounds are present in any of the above materials, curing may be impaired or even prevented.
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons. Prolonged exposure to air and light, especially UV light, may result in an increased brown discoloration, or development of turbidity. Since the colloidal platinum formed is also catalytically active, it is safe to assume that a brown discoloration and slight turbidity will not have a detrimental effect on the performance of the product.