ELASTOSIL® N 2137
ELASTOSIL® N 2137 is a non-slump, one-part silicone rubber for sealing and bonding applications. When exposed to air moisture it cures at room temperature to yield a permanently flexible silicone rubber with excellent heat resistance.
Fully vulcanized ELASTOSIL® N 2137 shows long-term stability against weathering, moisture and UV radiation. The silicone
elastomer may continously be exposed to constantly changing climatic conditions, UV radiation and temperature as high as
180 °C (356 °F) without damage.
- Stiff pasty consistency
- By-product of curing: alcohol
- Medium hardness
- Designed as gap sealant and bonding agent
- Improved resistance against motor oil and coolants
- Recommended service temperature range: -50 °C to +180 °C
ELASTOSIL® N 2137的特殊性能
- 交联性能: 单组分
- 交联性能: 缩合固化
- 具体特征: 单组分
- 具体特征: 电绝缘性
- 具体特征: 缩合固化
- 具体特征: 耐油性
- 具体特征: 耐紫外线性和耐候性
- 具体特征: 触变
- 流变性: 触变
- 硫化胶: 电绝缘性
- 耐久性: 耐油性
- 耐久性: 耐紫外线性和耐候性
- 表面效应: 耐油性
- General-purpose FIPG grade for technical applications
- Sealant for automotive applications
ELASTOSIL® N 2137 is a is a ready-to-use, one-part silicone rubber which starts curing when exposed to air moisture. Typical curing characteristics are given in the table "Properties Uncured".
As RTV-1 silicones require humidity for curing, free access of air moisture to the silicone rubber is essential. Additionally, the vulcanization time of ELASTOSIL® N 2137 can be greatly reduced by increasing the level of air's relative humidity. Please note that, unlike the initial skin formation, the total curing rate of RTV-1 silicones is limited by moisture's diffusion speed in silicone rubber.
Since increasing the curing temperature has just a minor effect both on the skin formation time and the curing speed, ELASTOSIL® N 2137 typically is vulcanized at room temperature.
After completion of the vulcanization the silicone elastomer may continuously be exposed to constantly changing climatic conditions, UV radiation and high temperature without damage. Cured ELASTOSIL® N 2137 usually shows good primerless adhesion to many substrates, e.g. glass, ceramics, metals, plastics, powder coatings and materials based on wood.
Detailed information about the processing of RTV-1 silicones is given in our brochure “ROOM TEMPERATURE VULCANIZING (RTV) SILICONES - MATERIAL AND PROCESSING GUIDELINES”. We recommend running preliminary tests to optimize conditions for the particular application.
If removal of the silicone from machines or dispensing equipment is necessary, white spirit or similar nonpolar solvents are recommended. However, cleaning ideally should take place before the silicone rubber is fully vulcanized. Cured silicone needs to be rubbed off or removed mechanically, if necessary in combination with a swelling agent (solvent) or a chemical silicone remover.
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable.
In this case however, the properties required for the intended use must be checked for quality assurance reasons.