VINNAPAS® EZ 3112
VINNAPAS® EZ 3112 is a protective colloid stabilized dispersion of a vinyl acetate, ethylene and vinyl ester terpolymer.
VINNAPAS® EZ 3112 is free from alkyl phenol ethoxylate (APEO) containing compounds.
- Fire resistance classes up to F120 achievable
- Excellent adhesion to substrates such as structural steelwork
- Significant foam development and expansion
- Higher hydrophobicity than standard VAEs
- Supports formulations without coalescing solvents
- Suitable for formulating very-low-VOC (< 1 g/l) intumescent coatings
- Produced without the use of APEOs
VINNAPAS® EZ 3112 is designed as a binder for high performance intumescent paints.
VINNAPAS® EZ 3112 is compatible with multivalent salts and other ingredients which are typically used for intumescent paints.
Due to its low minimum film forming temperature of approx. 0°C VINNAPAS® EZ 3112 doesn’t need any coalescence aids for filming.
如果 ???000012286??? 被应用于上述所提及以外的领域, 对 ???000012286??? 的选择, 处理及使用皆由购买方自行负责, 且所有行为必须依照法律法规.
Wacker Chemie AG
When the dispersion is stored in tanks, proper storage conditions must be maintained. The product has a shelf life of 6 months starting from the date of receipt if stored in the original, unopened containers at temperatures between 5 and 30 °C. Any longer periods for the maximum storage period that may be described in the Certificate of Analysis which accompanies each shipment of the product, take preference over this suggestion in which case the time period stated in the Certificate of Analysis shall be solely authoritative. Iron or galvanized iron containers and equipment are not recommended. Corrosion could result in discoloration of the dispersion or blends made from it in further processing. We therefore recommend the use of containers and equipment made of ceramic, rubberized or enameled materials, appropriately finished stainless steel, or plastic (rigid PVC, polyethylene or polyester resin). As polymer dispersions may tend to superficial film formation, skins or lumps may be formed during storage or transportation. A filtration process is thus recommended prior to utilization of the product.
Preservation for Transport, Storage and further Processing
The product is adequately preserved during transportation and storage if kept in the original, unopened containers. However, if it is transferred to storage tanks, the dispersion should be protected against microbial attack by adding a suitable preservative package.
Measures should also be taken to ensure cleanliness of the tanks and pipes. In unstirred tanks, a layer of preservative-containing water should be sprayed onto the surface of the dispersion to prevent the formation of unwanted skin and possible attack by microorganisms. The thickness of this water layer should be < 5 mm for low viscosity dispersions and up to 10–20 mm for high viscosity products. Proper procedures – periodic tank cleaning and sanitization – must be set up in order to prevent microbial attack. Contact your biocide representative/supplier for further plant hygiene recommendations. Measures should be taken to ensure that only clean air enters the tank when the dispersion is removed.
Finished products manufactured from polymer dispersions usually also require preservation. The type and scope of preservation will depend on the raw materials used and the anticipated sources of contamination. The compatibility with other components and the efficacy of the preservative should always be tested in the respective formulation. Preservative manufacturers will be able to advise you about the type and dosage of preservative required.