VINNAPAS® EP 3036 NJG
VINNAPAS® EP 3036 (NJG) is a high-viscosity, low formaldehyde and low free VAM residue vinyl acetate ethylene copolymer dispersion. This emulsion contains no solvent or plasticizer, has very low VOC content, and does not contain alkylphenol polyoxyethylene ether (APEO).
- Excellent compatibility with fillers and pigment
- Excellent compatibility with other additives
- Good adhesion with substrate
VINNAPAS® EP 3036 (NJG) is chemically stable at both high and low pH. It is compatible with other materials in the coating formulation as well as the other VINNAPAS® EP dispersions.
VINNAPAS® EP 3036 is designed as a binder for high performance thick fire-retardant coating.
VINNAPAS® EP 3036 is compatible with other ingredients which are typically used for thick fire- retardant coating.
Due to its low minimum film forming temperature of approx. 0°C, VINNAPAS® EP 3036 doesn’t need any coalescence agent for filming.
如果 ???000012286??? 被应用于上述所提及以外的领域, 对 ???000012286??? 的选择, 处理及使用皆由购买方自行负责, 且所有行为必须依照法律法规.
Wacker Chemie AG
When the dispersion is stored in tanks, proper storage conditions must be maintained. The product has a shelf life of 9 months starting from the date of manufacture if stored in the original, unopened containers at temperatures between 5 and 30°C. Please refer to "Best use before date" on the packaging label. Storage beyond the date specified does not mean that the product can´t be used anymore, but the user should perform a quality check on the properties necessary for the intended application. Any longer periods for the maximum storage period that may be described in the Certificate of Analysis which accompanies each shipment of the product, take preference over this suggestion in which case the time period stated in the Certificate of Analysis shall be solely authoritative. Iron or galvanized-iron equipment and containers are not recommended because the dispersion is slightly acidic. Corrosion may result in discoloration of the dispersion or its blends when further processed. Therefore, the use of containers and equipment made of ceramics, rubberized or enameled materials, appropriately finished stainless steel, or plastic (e.g. rigid PVC, polyethylene or polyester resin) is recommended. As polymer dispersions may tend to superficial film formation, skins or lumps may form during storage or transportation. Filtration is therefore recommended prior to utilization of the product.
Preservation for Transport, Storage and further Processing
The product is adequately preserved during transportation and storage if kept in the original, unopened containers. However, if it is transferred to storage tanks, the dispersion should be protected against microbial attack by adding a suitable preservative package.
Measures should also be taken to ensure cleanliness of the tanks and pipes. In unstirred tanks, a layer of preservative-containing water should be sprayed onto the surface of the dispersion to prevent the formation of unwanted skin and possible attack by microorganisms. The thickness of this water layer should be < 5 mm for low viscosity dispersions and up to 10-20 mm for high viscosity products. Proper procedures - periodic tank cleaning and sanitization - must be set up in order to prevent microbial attack. Contact your biocide representative/supplier for further plant hygiene recommendations. Measures should be taken to ensure that only clean air enters the tank when the dispersion is removed.
Finished products manufactured from polymer dispersions usually also require preservation. The type and scope of preservation will depend on the raw materials used and the anticipated sources of contamination. The compatibility with other components and the efficacy of the preservative should always be tested in the respective formulation. Preservative manufacturers will be able to advise you about the type and dosage of preservative required.