Our system has detected that you are from United States, which is why this country has been selected. Do you still wish to change your country?

SEMICOSIL® 911 A/B

SEMICOSIL® 911 A/B is a pourable, addition-curing, two-part silicone rubber that cures to a soft silicone gel.



Properties

  •  two-part, 1 : 1 mixing ratio
  •  thixotropic
  •  rapid heat cure
  •  forms a soft gel on vulcanization
  •  low content of volatiles
  •  low content of uncured polymer
  •  almost constant properties between -40 °C and +180 °C
  •  low ion content

Disclaimer

All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.

Because of the thixotropic behaviour, SEMICOSIL® 911 A/B is specially recommended for local encapsulation of delicate electronic components.

Surface preparation:
All surfaces must be clean and free of contaminants that will inhibit the cure of SEMICOSIL® 911 A/B. Examples of inhibiting contaminants are sulfur containing materials, plasticizers, urethanes, amine containing materials and organometallic compounds – especially organotin compounds. If a substrate’s ability to inhibit cure is unknown, a small scale test should be run to determine compatibility.


Mixing
Component A of SEMICOSIL® 911 A/B contains the platinum catalyst, component B the crosslinker. Even traces of the platinum catalyst may cause gelling of the component containing the crosslinker. Therefore tools (spatula, stirrers, etc.) used for handling the platinum-containing component or the catalyzed compound must not come into contact with this component. The two components should be thoroughly mixed at a 1 : 1 ratio by weight or volume. To eliminate any air introduced during mixing or trapped under components or devices a vacuum de-airing under a vacuum of 10 - 20 mm mercury for 5 - 10 min is recommended.


Curing
Curing time of addition-curing silicone rubber is highly dependent on temperature, size and heat sink properties of the component being potted.


Temperature            Curing time

100 °C                      5 min
130 °C                      2 min


We recommend running preliminary tests to optimize conditions for the particular application. Comprehensive processing instructions are given in our leaflet "Wacker RTV-2 Silicone Rubber - Processing".
 

Storage

The 'Best use before end' date of each batch is shown on the product label.

Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Sales and support

Wacker Chemical Corporation
3301 Sutton Road
Adrian 49221-9397
United States
+1  888  922-5374 (Phone)
+1 517 264-8246  (Fax)
Contact sales
Website

How can we help you?

    Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Ask a question

Would you like a product sample?

You can request a product sample here.

Request sample