SILPURAN® 2122 A/B
Two-component, addition-curing silicone composition curing to a soft silicone adhesive with high adhesive strength
- biocompatible, certificates of compatibility with USP Class VI and ISO 10993 available on request
- no by-products from curing process
- low viscosity, easily pourable
- mixing ratio 1 : 1
- very good adhesion, typical value 5.5 N/2.5 cm (90° peel test, on stainless steel)
- high transparency
Specific features of SILPURAN® 2122 A/B
- Addition Curing
- Suitable for skin contact
SILPURAN® 2122 A/B can be used as a skin adhesive in medical applications.
Components A and B of SILPURAN® 2122 A/B are mixed homogeneously in a ratio A : B = 1 : 1 and vulcanize rapidly at temperatures over 100 °C.
SILPURAN® 2122 A/B has good adhesive properties that can be adjusted to suit the relevant requirements:
Increasing the proportion of component A results in a softer vulcanisate and increased tackiness. Increasing the proportion of component B results in a harder vulcanisate and reduced tackiness.
The platinum catalyst is contained in component A.
Only components A and B with the same lot number may be processed together!
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.