SILPURAN® 2110 A/B
Two-component, addition-curing silicone composition curing to a soft silicone adhesive
- biocompatible, certificates of compatibility with USP Class VI and ISO 10993 available on request
- no by-products from curing process
- medium viscosity, pourable
- mixing ratio 1 : 1
- good adhesion, typical value 2.1 N/2.5 cm (90° peel test, on stainless steel)
- high transparency
Specific features of SILPURAN® 2110 A/B
- Addition Curing
- Suitable for skin contact
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
SILPURAN® 2110 A/B can be used as a skin adhesive in medical applications.
Components A and B of SILPURAN® 2110 A/B are mixed homogeneously in a ratio A : B = 1 : 1 and vulcanise rapidly at temperatures over 100 °C.
SILPURAN® 2110 A/B has good adhesive properties that can be adjusted to suit the relevant requirements:
Increasing the proportion of component A results in a softer vulcanisate and increased tackiness. Increasing the proportion of component B results in a harder vulcanisate and reduced tackiness.
The platinum catalyst is contained in component A.
Only A and B components with the same batch number may be processed together!
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.