ELASTOSIL® RT 702 WHITE
ELASTOSIL® RT 702 WHITE is a non-slump, one-part heat-curing silicone adhesive.
Cured ELASTOSIL® RT 702 WHITE shows very good adhesion to many substrates and long-term stability against weathering, moisture and UV light. The cured silicone rubber may continuously be exposed to constantly changing climatic conditions, UV radiation and temperatures as high as 210 °C (410 °F) without damage.
- Fast curing at elevated temperature
- Suitable for FIPG and, to a certain degree, for CIPG applications
- Excellent heat stability
- Recommended service temperature range: -50 °C to +210 °C
Specific features of ELASTOSIL® RT 702 WHITE
- Electrically insulating
- Heat resistant
- UV & weathering-resistant
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
- Multipurpose adhesive
- Typical fields of application: household appliances, automotive, lighting, mechanical engineering.
All surfaces must be clean and free of contaminants that will inhibit the cure of ELASTOSIL® RT 702 WHITE. Examples of inhibiting contaminants are sulfur containing materials, plasticizers, urethanes, amine containing materials and organometallic compounds – especially organotin compounds. If a substrate’s ability to inhibit cure is unknown, a small scale test should be run to determine compatibility.
To reduce the risk of bubbles or void formation during curing, ELASTOSIL® RT 702 WHITE can be de-aerated prior to use by applying a vacuum of 25-50 mbar for 10-15 min.
ELASTOSIL® RT 702 WHITE is a one-part heat-curing silicone, the curing time of which is highly dependent on temperature and on both the size and the heat sink properties of the parts to be bonded. ELASTOSIL® RT 702 WHITE is usually cured between 140 °C and 200 °C in order to secure a quick build-up of adhesion to the respective substrates. Typical curing temperatures and resulting curing times are given in adjacent table.
Detailed information about processing one-part heat-curing silicones is given in our brochure “ROOM TEMPERATURE VULCANIZING (RTV) SILICONES - MATERIAL AND PROCESSING GUIDELINES”. We recommend running preliminary tests to optimize conditions for the particular application.
If removal of the silicone from machines or dispensing equipment is necessary, white spirit or similar nonpolar solvents are recommended. However, cleaning ideally should take place before the silicone is fully vulcanized. Cured silicone rubber needs to be rubbed off or removed mechanically, if necessary in combination with a swelling agent (solvent) or a chemical silicone remover.
Store in a dry and cool place.
The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.