SILFAR® 100 is a polydimethylsiloxane obtained by hydrolysis and polycondensation of dichlorodimethyl-silane and chlorotrimethylsilane. The degree of polymerization (n) is such that the mean kinematic viscosity is 100mm²/s at 25°C.
SILFAR® 100 complies with the requirements set down in the monographs Dimeticone (EP) and "Dimethicone" (USP / NF). Wacker explicitly rules out the use of SILFAR® 100 for parenteral applications.
National regulations applicable in the countries concerned must be observed.
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
SILFAR® 100 is used predominantly in the pharmaceutical sector e.g. as an basic raw material in phamaceutical formulations.
Further information for storage: Keep container tightly closed. Store container(s) at room temperature in a dry, well-ventilated place.The 'Best use before end' date of each batch is shown on the product label.
Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.
Produced according ISO 9001, ISO 14001
Sales and support
How can we help you?
- Do you need help in choosing a product or do you require technical support? If so, please contact our experts.
Would you like a product sample?
You can request a product sample here.Request sample
There are no comparable products